Water is always a top priority in survival situations. However, locating clean drinking water sources is so hard that camping near the coast might seem like a practical solution. However, your problem now turns from finding water to making the salty water around you actually drinkable. Fortunately, you can make saltwater safe to drink using basic desalination methods that use common survival materials.
Why You Can’t Drink Seawater
Saltwater can cause more harm than good when consumed directly. The body depends on a balance between water and sodium, and seawater contains far more salt than the kidneys can filter out. When you drink seawater, the salt draws water out of your cells which causes dehydration and strains the kidney.
Unfortunately, boiling seawater won’t solve the problem because the salt remains even as the water evaporates. This is the reason why capturing and condensing the steam is necessary. That principle is the core of the desalination methods outlined below.
Fire-Based Distillation Setup
Fire-based distillation uses heat to separate fresh water from saltwater through evaporation and condensation. It’s especially useful when you have limited fuel and must make the most of a single fire source.
Materials Needed:
- A metal pot with a lid
- A smaller heatproof container or cup
- Fire or stove
- Optional: tarp or poncho for steam capture
How It Works:
Start by filling the pot with seawater, keeping the level low enough to prevent contact with the inner container. Place a smaller cup or bowl at the center of the pot and make sure it stays upright and doesn’t float. Then, place the lid upside down to cover the pot. Its shape will help direct condensation back toward the pot’s center.
As the water reaches a boil, steam will rise and come into contact with the cooler underside of the lid. The vapor will then condense into droplets that move along the surface and fall into the cup below. As a result, you’ll get salt-free water that’s safe to drink.
Solar Still in the Ground
A solar still is ideal when your location is sunny. It uses the sun’s heat to evaporate water slowly and uses condensation to collect drinkable liquid.
Materials Needed:
- A digging tool or shovel
- A piece of plastic or clear tarp
- A small container
- Rocks or weights
- Optional: green leaves or moist materials
How It Works:
Dig a shallow pit about two feet across and place a clean container in the center of the hole. Then, pour seawater directly into the soil surrounding the container. To increase humidity, pack wet leaves or soaked cloth around the vessel.
Next, cover the pit with a clear plastic sheet and press down the edges using rocks or packed soil to hold it in place. Place a small stone in the center of the plastic to create a dip. As sunlight heats the air inside the pit, moisture will evaporate from the seawater and damp materials. Vapor will rise, collect on the underside of the plastic, and start to cool. As a result, droplets will form, slide toward the dip and drip into the container below.
Plastic Bottle and Can (Field Improvisation)
This plastic bottle and can setup rely on sunlight to heat seawater inside a sealed container setup. It’s a simple way to mimic a solar still when you only have basic items on hand.
Materials Needed:
- One large plastic bottle
- One aluminum can
- Small knife, multitool, or survival blade
How It Works:
Cut the bottom off a clear plastic bottle to create an open end. Then take an aluminum can and remove its top to create a wide opening. Pour seawater into the can until it’s about half full, then place it on a flat surface under direct sun. Position the plastic bottle upside down over the can, with the bottle’s neck pointing downward. Press the sides of the bottle inward to form a low spot where condensed water can gather.
Once sunlight starts to heat the setup, the air inside the inverted bottle will warm up. As the seawater in the can heats, it will start to evaporate and steam will rise and touch the cooler inner surface of the plastic bottle. There, the vapor will condense into droplets, which will then slide downward and collect at the neck of the inverted bottle.
Turning the Tide: Make Seawater Work for You
Saltwater is easy to find, but it’s useless if you don’t know how to make it safe. Knowing desalination methods could be the difference between staying hydrated and running out of time. In a real emergency, would you be ready to make your own drinking water?
FAQs: Desalination Methods for Survival
- What is desalination, and why is it critical in survival?
Desalination removes salt from seawater, turning it into drinkable water when no freshwater source is available. - Can you safely drink seawater in small amounts?
No. Even a small amount of saltwater increases dehydration and stresses the kidneys. - Is boiling seawater enough to make it safe?
No. Boiling alone leaves the salt behind. You must collect the steam separately to get freshwater. - What’s the easiest desalination method to set up in the wild?
A fire-based distillation setup is usually easiest if you have basic gear and a stable heat source. - How long does a solar still take to produce water?
Most stills begin to collect water after 12 to 24 hours, depending on sunlight and humidity. - Can you reuse the same desalination setup multiple times?
Yes. As long as your materials stay intact and clean, each setup can be reused as needed. - How much water can one still or bottle setup produce per day?
Expect small yields—often a few ounces per day per unit. Running multiple setups increases output. - Are there risks to drinking distilled water in survival?
No immediate risks. While distilled water lacks minerals, it’s safe to drink in short-term situations. - What if I don’t have a plastic sheet for a solar still?
In an emergency, you can use clear food packaging, a poncho, or salvage plastic debris. - Should I rely on desalination alone for water in a survival plan?
No. It’s a backup skill. Always combine desalination with rainwater collection and stored supplies when possible.
